Hello,

We are writing an interactive test for uboot.

Here is the command we send:

timer start && nand read \${TMPADDR} ${nand_offset} \${TMPSIZE} && timer get || run fail

And below is what we get.

In the traces, after the “524288 bytes read: OK”, there is the timer info: 0.080.

We need to be able to catch this value and we need to perform computation on it and some comparison afterwards.

Do you have a solution to do that?

What would you advise us to do?

Thanks a lot for your help!

Best regards,

Roselyne Mazières

Internal