Good morning everyone!

While running some tests using our Linux distro and a SuperMicro Intel D1521 board, we encounter a situation where a very long line (shown as a "broken line" in LAVA's logs - in the WEB UI) seems to interfere with the job run, in a sense that the job eventually ends in a timeout.

This does not happen when that particular set of tests is not run and I am wondering if this might be a LAVA issue.

--------------------
A bit of context, first.

SuperMicro boards "make sure" your board connection options are limited to using SoL (serial-over-lan), IPMI and a serial port (but in a very limited manner).
One is not able to do a "typical" image load, since you may not specify hardware addresses or properly interact with the bootloader.

This led to an approach which is best illustrated in the attached diagram. 

For short: LAVA instantiates an LXC container, from where we run a series of scripts to prepare the board (copy some images & files on an already available Linux instance, altering the Grub menu and then rebooting the board, making it start the image we wish to test) and then run remote commands via SSH.
So, basically, the LXC container runs each and every command on the board, acting as the middleman.
-------------------

Now, we have the following:

Is there a way to further investigate if this type of output is "giving LAVA a hard time"? Is there a setting that limits interpreted output, somehow?

May it be that this is a LAVA issue? 

Kind regards!