On Thu, 15 Aug 2019 at 13:22, Fedusiv Ilya fedusivilya@gmail.com wrote:
Hello LAVA Team!
Found in manual about adding new device, at begin better to write to you.
Device is: aarch64 Flashing via fastboot (have partition table list) Device has serial debug connection.
For flashing using next commands: fastboot flash <partition name> <path> ... ... fastboot set_active a fastboot reboot
To turn device into fastboot mode need to enter command in serial debug.
It's either sth very similar to am6 or x15: https://git.lavasoftware.org/lava/lava/blob/master/etc/dispatcher-config/dev... https://git.lavasoftware.org/lava/lava/blob/master/etc/dispatcher-config/dev... They both use fastboot from u-boot shell. If your device is different you might check hikey: https://git.lavasoftware.org/lava/lava/blob/master/etc/dispatcher-config/dev...
I remember using set_active so it's supported in LAVA for sure. I just don't remember how to trigger it. To sum up, this should be fairly straight forward.
milosz
Best regards, Ilya Fedusiv
Lava-users mailing list Lava-users@lists.lavasoftware.org https://lists.lavasoftware.org/mailman/listinfo/lava-users