Hello LAVA experts,
I have a device which can boot up to android/linux. The device is connected with two USB cables. One USB cable is used for flashing images (fastboot flash) and doing some adb shell commands. Via another USB cable, I can use minicom to check uart logs and directly interact with the device (/dev/ttyUSB0).
Can you share some examples (jobs, job definitions) or configurations (like ser2net conf) or any suggestion for doing below test steps on my device with LAVA?
Scenario 1: 1. Flash images using fastboot 2. After android boots up or linux boots up, reboot and then stop at uboot 3. Do some tests in uboot.
Scenario 2: 1. Flash images using fastboot 2. After android boots up or linux boots up, interact with the device via uart (/dev/ttyUSB0) (suppose adb is disconnected) 3. Do some tests via uart.
Best regards, Kingboli