Hi Remi,
As i conveyed to you in earlier mail , we are able to boot the STM32F42xxx/F43xxx by flashing the .hex image file into the target through ST Link utility via USB.
Here I have attached the sequences of flashing the image on board & Board setup. PFA.
Thanks & Regards, Dhanunjaya
Dhanunjaya. P
On Thu, Nov 28, 2019 at 7:17 PM Remi Duraffort remi.duraffort@linaro.org wrote:
What kind of command do you run to flash over usb?
Le jeu. 28 nov. 2019 à 13:26, dhanu msys dhanuskd.palnati@gmail.com a écrit :
Hi Remi,
We were flashing through USB otg cable.
USB deploy method supported by lava right?
Regards, Dhanunjaya
On Thu, Nov 28, 2019, 17:52 Remi Duraffort remi.duraffort@linaro.org wrote:
Hello,
you should give more information if you want to have a proper answer.
How do you flash the board? is it fully automatic? Is this method already supported by LAVA?
Rgds
Le jeu. 28 nov. 2019 à 07:48, dhanu msys dhanuskd.palnati@gmail.com a écrit :
Hi Team,
How can i deploy RTOS based Application Image on target.
Notes : Target HW : STM32F429I-DISC1. RTOS : Open source RTOS Application Image (RTOS + Application specific code).
We are able to flash the Developed Application Firmware (.out/.bin) through IAR IDE via USB, so we are in plan to make use of LAVA and run test applications automatically.
So , Can you please provide some references to deploy this test scenarios in LAVA.
Thanks & Regards, Dhanunjaya. P _______________________________________________ Lava-users mailing list Lava-users@lists.lavasoftware.org https://lists.lavasoftware.org/mailman/listinfo/lava-users
-- Rémi Duraffort LAVA Architect Linaro
-- Rémi Duraffort LAVA Architect Linaro
