Just as the subject says. I am using lava-test-case to confirm whether this particular command is done running and is successful or not, because the test has previously always ended prematurely and not done what I needed it to do. When I run the command manually outside of a lava test job it works just fine, no errors and doesn't end early. It does take a while to complete, but I don't think that's the issue as I use wget to download some large files and those have taken several minutes longer than this one command is supposed to.
How do I get lava to wait for this command to end? Or to change how it checks for command failure?
I get "Received signal: <ENDTC>" almost immediately after running the command, and subsequently the result=fail signal. I really don't know why it won't work, so if there is a change I can make to the files or a config somewhere I would like to know.
Best regards,
Michael
