Hello,
you can test all device config using: /usr/share/lava-server/check-devices.py --device-types /etc/lava-server/dispatcher-config/device-types --devices /etc/lava-server/dispatcher-config/devices
Cheers
Le mer. 13 mars 2019 à 07:49, Frank, Matthias Matthias.Frank@tq-group.com a écrit :
Hi Rémi,
thank you for your answer.
This commands says same like the WebUI: Invalid configuration. But where can I found information what’s wrong? I did not found any parser or validator output which shows me the error.
Greetings, Matthias
*Von:* Remi Duraffort [mailto:remi.duraffort@linaro.org] *Gesendet:* Dienstag, 12. März 2019 17:57 *An:* Frank, Matthias Matthias.Frank@tq-group.com *Cc:* lava-users@lists.lavasoftware.org *Betreff:* Re: [Lava-users] Invalid device configuration
Hello Frank,
on the server you could run: "lava-server manage check --deploy"
This will run some checks on the current setup. This will also check that the health-checks that you provide are valid job definitions.
Rgds
Le lun. 11 mars 2019 à 16:16, Frank, Matthias Matthias.Frank@tq-group.com a écrit :
Hello lava users,
my lava 2019.01 shows me a device with Health == Bad. The Transitions log give that message:
March11, 3:02p.m.
lava-health
Good → Bad (Invalid device configuration)
Where can I found information about a misconfigured device? The log files did not provide (in my eyes) sufficient information.
As Health checks I use the smoke-tests.
Kinds Regards,
Matthias
Lava-users mailing list Lava-users@lists.lavasoftware.org https://lists.lavasoftware.org/mailman/listinfo/lava-users
--
Rémi Duraffort
LAVA Team, Linaro