Hello,

We are writing an interactive test for uboot.

Here is the command we send: timer start && nand read ${TMPADDR} ${nand_offset} ${TMPSIZE} && timer get || run fail And below is what we get. In the traces, after the "524288 bytes read: OK", there is the timer info: 0.080. We need to be able to catch this value and we need to perform computation on it and some comparison afterwards. Do you have a solution to do that? What would you advise us to do?

Thanks a lot for your help! Best regards, Roselyne Mazières

[cid:image001.png@01D837B6.3FFE36F0]

Internal